VMIC PMV-5565PIORC-21000 Ultrahigh Speed Fiber-Optic Reflective Memory Hardware Reference
PMC‐5565PIORC has an optical transceiver and three LEDs, located at
The front panel shown in the figure below. Table 1‐3 on page 31 summarizes the front.
Led of the panel. The port marked “RX” is the receiver, and the port marked “TX” is
Transmitter. PMC 5565 piorc uses “LC” type optical cable.
warn
When the optical fiber cable is not connected, the provided dust cover needs to be installed.
Installed to prevent dust and dirt from entering the optical system. Don’t energize.
PMC-5565PIORC without optical cable installed. This may cause eyes
Injured.
The default power-on state of the status LED is ON. The status LED is user-defined.
The board indicator can be switched on or off by writing bit 31 of the control.
And a status register. If the receiver detects light, the signal detection LED will light up.
And can be used to check whether the optical network
Connect to the receiver correctly. when
The board detected that its data was returned through the network. The default setting is off.
