Yokogawa PW481, PW482, PW484 Input Power Supply Module

n GENERAL

This General Specifications (GS) describes the hardware specifications of Power Supply Module. This model can be installed in Field Control Unit (FCU), FIO Node Unit or Optical ESB Bus Repeater Unit. Dual-redundant power supply can be configured by installing 2 modules.

n STANDARD SPECIFICATIONSS2]

Note: Other specifications are the same as that of FCU, FIO Node Unit and Optical ESB Bus Repeater Unit. Refer to “Installation Guidance” (TI 33J01J10-01JA). Note: The output voltage and current are not specified, because PW48

 cannot be used as a generic power supply module. PW48

 is an exclusive module for FCU, FIO Node Unit and Optical ESB Bus Repeater Unit.

n INSTALLATION

Power Supply Module(PW481, PW482, PW484) can be installed in the following units.

FCU: AFV30D, AFV30S, A2FV50D, A2FV50S, A2FV70D, A2FV70S FIO

Node Unit: ANB10D, ANB10S, ANB11D, ANB11S Optical ESB Bus Repeater Unit: ANT10U Base Plate: A2BE1D, A2BE2D

• Power Supply Module must be installed in slots P1-P2.

• In the case of single configuration, Power Supply Module must be installed in slot P1.

• Dual-redundant configuration is enabled by installing 2 identical modules with the same model code.

n ORDERING INFORMATION

 100 – 120 V AC Input Power Supply Module

 220 – 240 V AC Input Power Supply Module

 24 V DC Input Power Supply Module

n APPLICABLE STANDARDS

Refer to “Integrated Production Control System CENTUM VP System Overview (GS 33J01A10-01EN).

n ORDERING INFORMATION

Specify model and suffix codes. For selecting the right products for explosion protection, please refer to TI 33Q01J30-01E without fail.

n TRADEMARK ACKNOWLEDGMENT

The names of corporations, organizations, products and logos herein are either registered trademarks or trademarks of Yokogawa Electric Corporation and their respective holders.